How to Remove and Replace HP Pavilion x360 Notebook PCs Battery

If you need to buy a new HP Pavilion x360 battery to replace your old one, you'd better read this passage before your action.
What you need:

• You need a Phillips head screwdriver.
• Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
• Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
• HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
• Do not remove a component from its protective packaging until you are ready to install it.

Attention:

1. The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
2. Before starting, power off the computer and wait for components to cool before starting these procedures.

Caution：

This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Removing the battery: (Make sure the computer is disconnected from power before starting.)

(1) Remove the base enclosure.

For instructions to remove the base enclosure, see the HP support document, Removing and Replacing the Base Enclosure.

(2)  Find the HP Pavilion x360 laptop battery cable.

(3)Disconnect the Pavilion x360 battery cable from its connector on the system board.

(4)Disconnect the speaker cable from the connector on the system board.

(5)Remove the speaker cable from the routing tabs on the battery.

Be sure to notice the routing of the speaker cable around the battery for later replacement.

(6) Remove the four screws that secure the battery to the top cover.

(7) Lift the Pavilion x360 battery off of the standoffs on the top cover.

Replacing the battery

1.Place the battery onto the standoffs

2.Replace the four screws that secure the battery to the top cover.

3.Route the speaker cable through the routing tabs on the battery.

4.Connect the speaker cable into its connector on the system board.

5.Connect the battery cable into its connector on the system board.

6. Replace the base enclosure.