How to Store laptop Batteries

The recommended storage temperature for most laptop batteries is 15°C (59°F); the extreme allowable temperature is –40°C to 50°C (–40°C to 122°F) for most chemistries. While lead acid must always be kept at full charge during storage, nickel- and lithium-based chemistries should be stored at around a 40 percent state-of-charge (SoC). This level minimizes age-related capacity loss while keeping the battery in operating condition and allowing self-discharge.

Finding the 40 percent SoC level is difficult because the open circuit voltage (OCV) of batteries does not lend itself well to state-of-charge estimations. For lack of better methods, voltage is nevertheless used as a rough fuel gauge indicator. The SoC of Li-ion is roughly 50 percent at 3.80V/cell and 40 percent at 3.75V/cell. Allow Li-ion to rest 90 minutes after charge or discharge before taking the voltage reading to get equilibrium.

SoC on nickel-based batteries is especially difficult to measure. A flat discharge curve, agitation after charge and discharge, and voltage change on temperature contribute to the fluctuations. Since no other estimation tool exists that is practical, and the charge level for storage is not all too critical for this chemistry, simply apply some charge if the battery is empty, and then make sure that the battery is kept in a cool and dry storage.

Storage will always cause batteries to age. Low temperature and partial SoC only slow the effect. Table 1 illustrates the recoverable capacity of lithium- and nickel-based batteries at various temperatures and charge levels over one year. The recovered capacity is defined as the available battery capacity after storage with a full charge.

You can store a sealed lead acid battery for up to two years. Since all batteries gradually self-discharge over time, it is important to check the voltage and/or specific gravity, and then apply a charge when the battery falls to 70 percent state-of-charge. This is typically the case at 2.07V/cell or 12.42V for a 12V pack. (The specific gravity at 70 percent charge is roughly 1.218.) Some lead acid batteries may have different readings and it is best to check the manufacturer’s instruction manual. Low charge induces sulfation, an oxidation layer on the negative plate that inhibits current flow. Topping charge and/or cycling may restore some of the capacity losses in the early stages of sulfation.